![]() ![]() Sometimes the computer can enter standby and thus the USB port is unavailable for power delivery. If the device is not charging: Always check if the red LED indicator is visible when the recorder is connected to your PC.If you connect the device to your computer and you don’t see the LightREC’s partition: check if the ON/OFF button is in the OFF position.You will need to disconnect the device from the computer, turn it off, and then reconnect it to be able to access the folder “RECORD”. NOTE: During recording, the partition of the recorder will not be visible on your computer. Please connect it to a power source (a computer or a charger) and switch the button to the “ON” position. The device can record and charge simultaneously. Note: If during recording the red LED starts flashing, the battery level is low and you should cha should charge your device. It can continuously work (in either recording mode) for about 27 hours on a full battery cycle. Once fully charged (typically in 1 hour), you can eject the device. When the LED stops flashing and stay lit the recorder is fully charged. When the red LED indicator is flashing the device is charging. Make sure to have both of the USB parts clicked in together (both the mini USB and the USB) and connect the recorder to your computer to charge. Then disconnect the recorder from your computer and perform a test recording. NOTE: Make sure to save the file in the folder “RECORD” below the subfolder “VOICE”. you should have in the time.txt file the following string of digits: 20190522172400 (no spaces before or after the string of digits). seconds.įor example, if today would be the 22nd of May 2019, time 05:24 P.M. is 06, etc mm – is 2 digit format for minutes and SS – is 2 digit format for seconds. HH – means 2 digit hour in the 24 hours format (no a.m. Open it with any text editor on your computer and input your current time and date in the following format: YYYYMMDDHHMMSS, where YYYY – is the four-digit year (ex. Right-click in the folder to select option “NEW” -> “Text Document”. Connect the device to your computer to access the folder RECORD. ![]()
0 Comments
Leave a Reply. |